cos φ = R / Z
cos φ is the power factor, R the resistance and Z the
impedance, both in ohms. φ is the angle the current lags
or leads the voltage by.
Holds for a series circuit with sinusoidal voltage and current. With harmonics, as from many power supplies,
cos φ alone no longer describes the power factor.
R = 30 Ω, Z = 50 Ω: cos φ = 30 / 50 = 0.6, so φ ≈ 53.13°.
R = 8 Ω, Z = 17 Ω: cos φ = 8 / 17 ≈ 0.4706, so φ ≈ 61.93°.
Watts and volt-amperes
In a direct-current circuit, power is voltage times
current. On AC, that product is only the apparent power, in volt-amperes. The part that becomes heat,
light or motion — the real power, in watts — is
P = U · I · cos φ
230 V, 5 A, cos φ = 0.6: the wires carry 230 · 5 = 1,150 VA, but only 1,150 · 0.6 = 690 W does work.
The rest sloshes back and forth between the source and the coils and capacitors every cycle.
| Load |
Typical power factor |
| Kettle, heater, incandescent bulb |
1 |
| Motor at full load |
about 0.8–0.9 |
| Motor running idle |
much lower |
Why it matters
The current that does no work still heats the cables and still has to be supplied by the grid. A factory
with a low power factor needs thicker cables and a larger transformer for the same useful power, which is
why utilities often charge large customers for it and why they fit capacitors to cancel the coils’
reactance — pushing cos φ back towards 1.
Common mistakes
- Multiplying volts by amps and calling it watts. On AC that is volt-amperes; multiply by cos φ as well.
- Using X instead of Z. cos φ = R / Z. X / Z is sin φ, the reactive share.
- Expecting a value above 1. Z is never smaller than R, so the power factor cannot exceed 1.
Questions people ask
Is a power factor of 1 always the goal?
For power delivery, yes: all the current does work. A circuit tuned to
resonance reaches it, since there Z = R.
What do “lagging” and “leading” mean?
Lagging: the current trails the voltage, as in a coil-heavy load like a motor. Leading: it runs ahead, as
in a capacitive load. The power factor is the same number either way; the words say which side it is on.