- ln(p₂ / p₁) = (L / R) · (1/T₁ − 1/T₂)
p₁ is the vapour pressure at temperature T₁, p₂ the vapour pressure at T₂, L the molar heat of
vaporisation in J/mol and R the gas constant, 8.314 J/(mol·K). Temperatures are in kelvins.
Holds when the vapour can be treated as an ideal gas and L as constant, within a few tens of degrees of a
known point.
A liquid boils when its vapour pressure equals the pressure around it. So one known point — water boils at
373.15 K under 101,325 Pa — and the heat of vaporisation give the whole curve near it.
Worked examples
Water at 90 °C. With L = 40,700 J/mol for water at its boiling point:
ln(p₂ / 101,325) = (40,700 / 8.314) · (1/373.15 − 1/363.15), so p₂ ≈ 70.6 kPa.
Boiling on a mountain. At about 3,000 m the air pressure is near 70 kPa. Solving for T₂ with
p₂ = 70,000 Pa gives 89.8 °C. Pasta takes noticeably longer, and an egg cooked for the usual time comes
out underdone.
The pressure cooker does the opposite. Raising the pressure inside raises the boiling point above
100 °C, and the food cooks faster.
Where it stops being accurate
The formula assumes the vapour behaves as an ideal gas, the liquid’s volume is negligible next to the
vapour’s, and L stays the same over the range. Over a few tens of degrees near normal pressure all three
hold well. Near the critical point, or over a range of a hundred degrees, L changes and the answer drifts;
engineering tables use the Antoine equation or measured data instead.
Common mistakes
- Using the heat per kilogram. L here is per mole. For water, 2,260 kJ/kg × 0.018 kg/mol ≈ 40.7 kJ/mol.
The latent heat page uses the per-kilogram value.
- Swapping the temperatures. A higher T₂ must give a higher p₂. If the pressure falls as the temperature
rises, the bracket has been reversed.
- Using Celsius. 1/90 and 1/100 are not 1/363.15 and 1/373.15.
Questions people ask
Does it work for sublimation too?
Yes, with the heat of sublimation in place of the heat of vaporisation. It gives the vapour pressure over
ice, which matters for frost and freeze-drying.
Why is it called a relation and not a law?
Clapeyron wrote the exact relation for the slope of any phase boundary; Clausius added the ideal-gas
approximation that makes it integrable. The form on this page is that integrated approximation.