What the calculator answers
A price means nothing until it is divided by an area. 450,000 and 530,000 cannot be compared; 6,250 and 6,023 per square metre can — and the two pairs describe the same two homes, with the opposite answer as to which is dearer.
It works both ways round. Choose Price per m² to divide a price by an area, or Total price to go the other way: what 24 m² of flooring costs when the floor is priced per square metre, or what a 72 m² home is worth at a given rate.
Formula
Price per m² = price / area
Total price = price per m² × area
One relation read from two ends. The third rearrangement — the area, expressed in terms of the price and the rate — is on the formula page price per square metre, which shows all three.
Worked example
450,000 over 72 m² is 6,250 per square metre.
530,000 over 88 m² is 6,023 per square metre. The larger, dearer property is the cheaper of the two per square metre, even though it costs 80,000 more.
450 per m² over 24 m² is 10,800 — the same sum backwards, for a floor.
Two floor areas
A listing often gives more than one area: the main floor area, and a secondary one covering a garage, a cellar or a loft. Which of them the price is divided by changes the answer, and not by a little. The same 3,600,000 property:
- over 72 m² of main floor area: 50,000 per m²
- over 72 + 18 m², both areas together: 40,000 per m²
Twenty percent apart. The calculator never weights one area against the other. It shows both figures and leaves the gap visible, deliberately: there is no single weighting we could point at a source for, and an invented one would look exactly as credible as a real one. The main-area figure is the upper bound, the both-areas figure the lower bound, and the comparable number lies somewhere between.
If the listing gives only one area, leave the second field at 0 and the combined figures show a dash.
Comparing two properties
The calculator has a second scenario. Enter one property as A and the other as B, and the difference between them is shown in money per square metre and in percent. That is where the page does something a phone does not: two rates side by side with the difference spelled out.
What is not included
- Service charges. A flat with a low price and a high monthly charge is not cheap, and a price per square metre cannot say so. Turning a charge into a price needs a yield assumption, and this page does not make one for you.
- Any share of a building’s debt. It sits outside the price and outside this sum.
- Running costs. What the home costs to live in is a different question — for electricity, see the electricity cost calculator.
- Waste and labour, if you are pricing a floor rather than a home.
Common questions
Should the secondary area be counted?
It depends who is doing the counting, which is why the page shows both. Divided by the main area alone
the figure is higher; divided by both areas together it is lower. We do not choose for you, because
there is no single weighting between the two that we could support with a source.
What is a normal price per square metre?
It depends entirely on where the property is, and that figure is not here. The page holds no market
values, indices or averages — every number on it is yours. Compare two real properties against each
other with the second scenario instead.
Can I use it for flooring, tiling or paint?
Yes — choose Total price, enter the price per square metre and the area, and you get what the
material costs for that area. Waste and labour are not included.
How is this different from the unit price calculator?
The unit price calculator turns a price and an amount into a price per
kilo, litre or piece, and does the unit conversion for you. This page has one unit only, the square
metre, but it works in both directions and handles a listing’s two floor areas.